Paasche-airbrush BUT Manuel d'utilisateur télécharger pdf

INSTRUCTION AND PARTS LIST BUB & BUT-8/31/2011

Supersedes Instruction & Parts list BU & BUT-6/2008

BUB- (Bottom Air Inlet)

BUT- (Thumb Action Trigger)

MANUAL SPRAY GUNS

OPERATING INSTRUCTIONS & REPLACEMENT PARTS

DESCRIPTION:

BUB- and BUT- Manual Spray Guns (“T” means thumb

action) are for use with Light to Medium consistency

materials. These models require 2 to 14 C.F.M. @ 30 to

40 P.S.I. air pressure depending on size of Multiplehead

selected.

AIR CONNECTIONS:

These models have 1/4'' N.P.T. Air Inlet.

1. Open air control valve and blow out Air Hose to

remove any foreign particles that may be in airline.

Secure air hose so it doesn’t injure anyone during

purging.

2. Connect air hose to the U-807 Air Inlet Tube on

BUB- Bottom Air Inlet Model. Connect air hose to

U-49A Valve Casing on BUT- Thumb Action Spray

Gun.

FLUID CONNECTIONS:

These models have 3/8'' N.P.T. Fluid Inlet.

1. For Siphon Feed, attach siphon feed cup to bottom

inlet of Fluid Body Assembly.

2. For Gravity Feed, loosen U-58 Nut and then turn

fluid inlet of Fluid Body Assembly to top of Spray

Gun and connect Gravity Feed Cup. Tighten U-58

Nut.

3. Pressure Tank operation requires that you attach

one end of fluid hose to pressure tank and the

other end to the fluid inlet on the Fluid Body

Assembly.

MATERIAL:

1. Mixture should be to the consistency

recommended by the manufacturer.

2. Strain all materials through a cloth or fine wire

mesh prior to using to insure all foreign particles

have been removed.

OPERATION:

1. Adjust 200-17 Fluid Knob on BUB- (Bottom air

inlet) Model to regulate the flow of material through

the Spray Gun.

2. To control fluid on the BUT- Spray Gun, adjust the

U-1816 Adjusting Screw on the trigger.

Grip Spray Gun as you would a pistol, place two fingers on

the trigger. The first one quarter inch pull releases air only

and is used for cleaning by dusting surfaces before

painting. Continued pull on the trigger retracts the Fluid

Needle and allows maximum fluid passage.

Begin Painting by applying as light a coat as possible. Take

long strokes from side to side releasing the trigger at the end

of each stroke. For average work, hold head of Spray Gun

6 to 8 inches from the surface; for narrow lines, use short

trigger pull and hold Spray Gun closer to the surface. To get

wider spray patterns, draw Spray Gun away from surface

gradually while trigger is pulled back until desired width of

pattern is obtained. Practice before spraying on your project

is always advisable.

CARE AND CLEANING:

Flush clean solvent through the fluid passages of the Spray

Gun and wipe off the outside. Never leave the entire Spray

Gun immersed in solvent or the leather packings will dry out.

Dirty Aircaps and Tips should be cleaned out by soaking in

solvent and then blown clean with air. Never use wire

objects to ream out the holes in aircaps or tips as this will

damage these items. Always follow safety instructions on

cleaning solvents being used and remember to keep your

containers closed in a safe location.

Paasche Airbrush Company

4311 North Normandy Avenue

Chicago, IL 60634-1395

Phone: 773-867-9191 • Fax: 773-867-9198

Website: paascheairbrush.com

E-Mail: [email protected]

Printed in the U.S.A.

WARNING: Spray materials may be harmful if inhaled or

allowed to come into contact with the skin or eyes. Consult

the product label and Material Safety Data Sheet supplied

for the spray material. Follow all safety precautions.

CAUTION: Well Ventilated Area Required to remove

fumes, dust or overspray. Secure airhose and fluid

hose wrench tight for safety and to prevent leaks.

M a x i m u m A i r P r e s s u r e 1 0 0 P . S . I .

M a x i m u m F l u i d P r e s s u r e 4 5 P. S . I .

1 2 3 4

Résumé du contenu

Page 1 - MANUAL SPRAY GUNS

INSTRUCTION AND PARTS LIST BUB & BUT-8/31/2011Supersedes Instruction & Parts list BU & BUT-6/2008BUB- (Bottom Air Inlet)BUT- (Thumb Actio

Page 2 - BUT- Thumb Action Spray Gun

Page 2BUB- Manual Spray GunsBUT- Thumb Action Spray Gun

Page 3

BUB & BUT PARTS LIST & ACCESSORIES1. U-2-3/8 Needle2. BU-7B Standard Fluid BodyU-3500 Packing Set (Same on all Models)3. U-28-12 Packing

Page 4

SPRAY HEAD COMPONENTSSpray Heads for BUB & BUT- Manual Spray Guns are available in several different Styles, some of which are

Modèles reliés BUB

Commentaires sur ces manuels

Pas de commentaire

Paasche-airbrush BUT Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Accessoires d'air Paasche-airbrush BUT. Paasche Airbrush BUT User Manual Manuel d'utilisatio

Résumé du contenu

Modèles reliés BUB

Commentaires sur ces manuels

Produits connexes et manuels pour Accessoires d'air Paasche-airbrush BUT